Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 938-793-9
CAS number: -
1.1. Indications on Safety Data Sheets (SDS) for the professional user about guidance on safe use of petroleum products, in all its aspects, should take into account that applicable legislation and general accepted practices for the management of industrial routine activities or emergencies, as well as company operating procedures, already compose a background which indicates which general actions are necessary/mandatory, advisable or unadvisable in such cases. An extensive recapitulation of all this background information will not necessarily add information value to a SDS, and may actually decrease the readability of the document, especially in an emergency. Therefore the indications meant for actual inclusion in SDSs can be focused (although not necessarily limited) to:
- Product specific issues (i.e. special hazards or characteristics)
- Key Actions (or group of actions) that are applicable in the specific case
1.2. The actual level of detail of information and its phrasing in individual SDSs may reflect local or national conventions or requirements, or company policies, but without infringing on the consistency with the information submitted hereunder. Also, more stringent national or local legal requirements or conventions will take precedence over the guidance provided in this document
2 Warning: before intervention
2.1 Spillages make surface slippery
2.2 Before attempting to rescue casualties, isolate area from all potential sources of ignition including disconnecting electrical supply.
2.3 Ensure adequate ventilation and check that a safe, breathable atmosphere is present before entry into confined spaces.
2.4 (Subject to applicability) Hydrogen sulphide (H2S) can accumulate in the headspace of storage tanks and reach potentially hazardous concentrations.
3.1 Inhalation at ambient temperature is unlikely because of the low vapour pressure of the substance. Exposure to vapours may however occur when the substance is handled at high temperatures with poor ventilation.
3.2 Symptoms: irritation of the respiratory tract due to excess fume, mists or vapour exposure.
3.3 In case of symptoms arising from inhalation of fumes or mists or vapours: Remove casualty to a quiet and well ventilated place if safe to do so
3.4 If casualty is unconscious and:
- Not breathing – ensure that there is no obstruction to breathing and give artificial respiration by trained personnel. If necessary, give external cardiac massage and obtain medical assistance.
- Breathing – place in the recovery position. Administer oxygen if necessary.
3.5 Obtain medical assistance if breathing remains difficult.
3.6 (subject to applicability) If there is any suspicion of inhalation of H2S:
* Rescuers must wear breathing apparatus, belt and safety rope, and follow rescue procedures.
* Remove casualty to fresh air as quickly as possible.
* Immediately begin artificial respiration if breathing has ceased.
* Provision of oxygen may help.
* Obtain medical advice for further treatment.
4 Skin Contact
4.1 Symptoms: reddening, irritation.
4.2 Remove contaminated clothing and footwear and dispose of safely.
4.3 Wash affected area thoroughly with soap and water.
4.4 Seek medical attention if skin irritation, swelling or redness develops and persists
4.5 (Subject to applicability – use as fuel or functional fluid) When using high-pressure equipment, injection of product can occur. If high-pressure injuries occur, immediately seek professional medical attention. Do not wait for symptoms to develop.
4.6 For minor thermal burns: Cool the burn. Hold the burned area under cold running water for at least five minutes, or until the pain subsides. However, body hypothermia must be avoided.
5 Eye Contact
5.1 Symptoms: slight irritation (unspecific).
5.2 Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do so. Continue rinsing.
5.3 If irritation, blurred vision or swelling occurs and persists, obtain medical advice from a specialist
6.1 Symptoms: few or no symptoms expected. If any, nausea and diarrhoea might occur.
6.2 In case of ingestion, always assume that aspiration has occurred. The casualty should be sent immediately to a hospital. Do not wait for symptoms to develop.
6.3 Do not induce vomiting as there is high risk of aspiration.
6.4 Do not give anything by mouth to an unconscious person.
1. Product specific hazards and other issues
1.1. This substance will float and can be reignited on surface water.
2. Extinguishing Media
- Foam (Specifically trained personnel only)
- Water fog (Specifically trained personnel only)
- Dry chemical powder
- Carbon dioxide
- Other inert gases (subject to regulations)
- Sand or earth
3. Unsuitable Extinguishing Media
3.1. Do not use direct water jets on the burning product; they could cause splattering and spread the fire.
3.2. Simultaneous use of foam and water on the same surface is to be avoided as water destroys the foam.
4. Combustion Products
4.1. Incomplete combustion is likely to give rise to a complex mixture of airborne solid and liquid particulates and gases, including carbon monoxide and unidentified organic and inorganic compounds.
4.2. If sulfur compounds are present in appreciable amounts, combustion products may include also H2S and SOx (sulfur oxides) or sulfuric acid.
5. Protective Equipment for Firefighters
5.1. In case of a large fire or in confined or poorly ventilated spaces wear full fire resistant protective clothing and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode.
1. General information
1.1. Stop or contain leak at the source if safe to do so. Avoid direct contact with released material. Stay upwind. In case of large spillages, alert occupants in downwind areas.
1.2. Keep non-involved personnel away from the area of spillage. Alert emergency personnel.
Except in case of small spillages, the feasibility of any actions should always be assessed and advised, if possible, by a trained, competent person in charge of managing the emergency.
1.3. Eliminate all ignition sources if safe to do so (e.g. electricity, sparks, fires, flares).
1.4. (Subject to applicability): In those cases when the presence of dangerous amounts of H2S around the spilled product is suspected or proved, additional or special actions may be warranted, including access restrictions, use of special protection equipment, procedures and personnel training
1.5. If required, notify relevant authorities according to all applicable regulations.
2. Personal protection equipment for emergency responders
2.1. Small spillages: normal antistatic working clothes are usually adequate. Large spillages: full body suit of chemically resistant and antistatic material.
2.2. Work gloves providing adequate chemical resistance, specifically to aromatic hydrocarbons. Note: gloves made of PVA are not water-resistant, and are not suitable for emergency use.
2.3. Work helmet. Antistatic non-skid safety shoes or boots
2.4. Goggles or face shield, if splashes or contact with eyes is possible or anticipated.
2.5. Respiratory protection: A half or full-face respirator with filter(s) for organic vapours (and when applicable for H2S) or a Self Contained Breathing Apparatus (SCBA) can be used according to the extent of spill and predictable amount of exposure. If the situation cannot be completely assessed, or if an oxygen deficiency is possible, only SCBA’s should be used.
3. Spillages onto Land
3.1. Prevent product from entering sewers, rivers, waterways or other bodies of water
3.2. If necessary dike the product with dry earth, sand or similar non-combustible materials.
3.3. Large spillages may be cautiously covered with foam, if available, to limit fire risk. Do not use direct jets
3.4. When inside buildings or confined spaces, ensure adequate ventilation.
3.5. Absorb spilled product with suitable non-combustible materials.
3.6. Collect free product with suitable means. .Transfer collected product and other contaminated materials to suitable containers for recycle, recovery or safe disposal.
3.7. In case soil contamination, remove contaminated soil and treat this in accordance with local regulations.
4. Spillages on water or at sea
4.1. In case of small spillages in closed waters (i.e. ports), contain product with floating barriers or other equipment. Collect spilled product by absorbing with specific floating absorbents
4.2. If possible, large spillages in open waters should be contained with floating barriers or other mechanical means. If this is not possible, control the spreading of the spillage, and collect the product by skimming or other suitable mechanical means.
4.3. The use of dispersants should be advised by an expert, and, if required, approved by local authorities.
4.4. Collect recovered product and other materials in suitable tanks or containers for recovery or safe disposal.
5. Additional information
5.1. Note: recommended measures are based on the most likely spillage scenarios for this material; however, local conditions (wind, air temperature, wave/current direction and speed) may significantly influence the choice of appropriate actions. For this reason, local experts should be consulted when necessary. Local regulations may also prescribe or limit actions to be taken.
5.2. (Subject to applicability): Concentration of H2S in tank headspaces may reach hazardous values, especially in case of prolonged storage. This situation is especially relevant for those operations which involve direct exposure to the vapours in the tank.
5.3. (Subject to applicability): Spillages of limited amounts of products, especially in the open air when vapours will be usually quickly dispersed, are dynamic situations, which are unlikely to entail exposure to dangerous concentrations. As H2S has a density greater than ambient air, a possible exception may regard the build-up of dangerous concentrations in specific spots, like trenches, depressions or confined spaces. In all these circumstances, however, the correct actions should be assessed on a case-by-case basis.
1. General Information
1.1. Ensure that all relevant regulations regarding handling and storage facilities of flammable products are followed.
1.2. (Subject to applicability) A specific assessment of inhalation risks from the presence of H2S in tank headspaces, confined spaces, product residue, tank waste and waste water, and unintentional releases must be made to help determine controls appropriate to local circumstances.
1.3. Keep away from heat/sparks/open flames/hot surfaces. – No smoking.
1.4. Use and store only outdoors or in a well-ventilated area.
1.5. Avoid contact with the product.
1.6. Avoid release to the environment.
2.1. Take precautionary measures against static electricity.
2.2. Ground/bond containers, tanks and transfer/receiving equipment.
2.3. Use only non-sparking tools.
2.4. The vapour is heavier than air. Beware of accumulation in pits and confined spaces.
2.5. Do not use compressed air for filling, discharging, or handling operations.
2.6. Avoid contact with skin and eyes. Do not ingest. Avoid breathing vapours.
2.7. Use personal protective equipment as required.
2.8. For more information regarding protective equipment and operational conditions see Exposure scenarios.
3.1. Storage area layout, tank design, equipment and operating procedures must comply with the relevant European, national or local legislation.
3.2. Storage installations should be designed with adequate bunds so as to prevent ground and water pollution in case of leaks or spills.
3.3. Cleaning, inspection and maintenance of internal structure of storage tanks must be done only by properly equipped and qualified personnel as defined by national, local or company regulations.
3.4. Before entering storage tanks and commencing any operation in a confined area check the atmosphere for oxygen content and flammability. (Subject to applicability) If sulphur compounds are suspected to be present in the product, check the atmosphere for H2S content.
3.5. Store separately from oxidising agents.
4. Recommended and Unsuitable Materials for Storage
4.1. Recommended materials: For containers, or container linings use mild steel, stainless steel.
4.2. Unsuitable materials: some synthetic materials may be unsuitable for containers or container linings depending on the material specification and intended use. Compatibility should be checked with the manufacturer
5. Container Advice
If the product is supplied in containers:
5.1. Keep only in the original container or in a suitable container for this kind of product.
5.2. Keep containers tightly closed and properly labelled. Protect from the sunlight.
5.3. Light hydrocarbon vapours can build up in the headspace of containers. These can cause flammability / explosion hazards.
5.4. Empty containers may contain flammable product residues. Do not weld, solder, drill, cut or incinerate empty containers, unless they have been properly cleaned.
6. Hygiene measures
6.1. Ensure that proper housekeeping measures are in place.
6.2. Contaminated materials should not be allowed to accumulate in the workplace and should never be kept inside the pockets.
6.3. Keep away from food and beverages.
6.4. Do not eat, drink or smoke while using this product
6.5. Wash the hands thoroughly after handling.
6.6. Change contaminated clothes at the end of working shift.
7. Additional information
7.1.(If Applicable – Substance registered as isolated intermediate under SCC) This substance is handled under Strictly Controlled Conditions in accordance with REACH regulation Article 17(3) for on-site isolated intermediates and, in case the substance is transported to other sites for further processing, the substance should be handled at these sites under the Strictly Controlled Conditions as specified in REACH regulation Article 18(4). Site documentation to support safe handling arrangements including the selection of engineering, administrative and personal protective equipment controls in accordance with risk-based management systems is available at each manufacturing site.
7.2.(If Applicable) Written confirmation of application of Strictly Controlled Conditions has been received from every affected Distributor and Downstream Processor/User of the Registrant’s intermediate
Note: In this case the information in heading 8 is not required, according to Art. 14 (1) and (2), and Annex VI, Sect. 5.6 of the Regulation.
The accompanying text is provided as applicable statements in case of a substance registered as an isolated intermediate or transported isolated intermediate under Strictly Controlled Conditions.
(If Applicable – Substance registered as isolated intermediate under SCC) This substance is handled under Strictly Controlled Conditions in accordance with REACH regulation Article 17(3) for on-site isolated intermediates and, in case the substance is transported to other sites for further processing, the substance should be handled at these sites under the Strictly Controlled Conditions as specified in REACH regulation Article 18(4). Site documentation to support safe handling arrangements including the selection of engineering, administrative and personal protective equipment controls in accordance with risk-based management systems is available at each manufacturing site.
(If Applicable) Written confirmation of application of Strictly Controlled Conditions has been received from every affected Distributor and Downstream Processor/User of the Registrant’s intermediate
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
På den här webbplatsen används kakor. Syftet är att optimera din upplevelse av den.
Welcome to the ECHA website. This site is not fully supported in Internet Explorer 7 (and earlier versions). Please upgrade your Internet Explorer to a newer version.
Do not show this message again