Registration Dossier

Administrative data

First-aid measures

Remove contaminated clothing. If the patient is likely to become unconscious, place and transport in stable sideways position (recovery position).
If inhaled:
Keep patient calm, remove to fresh air, seek medical attention.
On skin contact:
Wash thoroughly with soap and water.
On contact with eyes:
Wash affected eyes for at least 15 minutes under running water with eyelids held open. Seek medical attention.
On ingestion:
Immediately rinse mouth and then drink 200-300 ml of water, seek medical attention.

Fire-fighting measures

Extinguishing media
Suitable extinguishing media:
dry powder, alcohol-resistant foam, carbon dioxide
Special hazards arising from the substance or mixture
The product is combustible. Cool endangered containers with water-spray.
Advice for fire-fighters
Special protective equipment:
Wear a self-contained breathing apparatus.
Further information:
Collect contaminated extinguishing water separately, do not allow to reach sewage or effluent systems. Keep containers cool by spraying with water if exposed to fire. Foam should be applied in large quantities as it is broken down to some extent by the product.

Accidental release measures

Personal precautions, protective equipment and emergency procedures
Handle in accordance with good industrial hygiene and safety practice.
Environmental precautions
Do not discharge into the subsoil/soil. Do not discharge into drains/surface waters/groundwater.
Methods and material for containment and cleaning up
For large amounts: Pump off product.
For residues: Pick up with suitable absorbent material (e.g. sand, sawdust, general-purpose binder, kieselguhr). Dispose of contaminated material as prescribed.

Handling and storage

Precautions for safe handling
Ensure thorough ventilation of stores and work areas.
Protection against fire and explosion:
Prevent electrostatic charge - sources of ignition should be kept well clear - fire extinguishers should be kept handy.
Conditions for safe storage, including any incompatibilities
Further information on storage conditions: Containers should be stored tightly sealed in a dry place.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Exposure controls
Personal protective equipment
Respiratory protection:
Wear respiratory protection if ventilation is inadequate. Gas filter for gases/vapours of organic compounds (boiling point >65 °C, e. g. EN 14387 Type A)

Hand protection:
Chemical resistant protective gloves (EN 374)
Suitable materials also with prolonged, direct contact (Recommended: Protective index 6, corresponding > 480 minutes of permeation time according to EN 374):
butyl rubber (butyl) - 0.7 mm coating thickness
Manufacturer's directions for use should be observed because of great diversity of types.
Supplementary note: The specifications are based on tests, literature data and information of glove manufacturers or are derived from similar substances by analogy. Due to many conditions (e.g. temperature) it must be considered, that the practical usage of a chemical-protective glove in practice may be much shorter than the permeation time determined through testing.

Eye protection:
Safety glasses with side-shields (frame goggles) (e.g. EN 166)

Body protection:
Body protection must be chosen depending on activity and possible exposure, e.g. apron, protecting boots, chemical-protection suit (according to EN 14605 in case of splashes or EN ISO 13982 in case of dust).

General safety and hygiene measures
Handle in accordance with good industrial hygiene and safety practice. Wearing of closed work clothing is required additionally to the stated personal protection equipment.

Stability and reactivity

Reactivity;
Vapours may form explosive mixture with air.
Corrosion to metals:
Corrosive effects to metal are not anticipated.
Formation of flammable gases: Remarks: Forms no flammable gases in the presence of water.
Chemical stability;
The product is stable if stored and handled as prescribed/indicated.
Possibility of hazardous reactions;
Reacts with strong oxidizing agents.
Conditions to avoid;
No special precautions other than good housekeeping of chemicals.
Incompatible materials;
Substances to avoid:
strong oxidizing agents
Hazardous decomposition products;
No hazardous decomposition products if stored and handled as prescribed/indicated.

Disposal considerations

Waste treatment methods;
Must be disposed of or incinerated in accordance with local regulations.
Contaminated packaging should be emptied as far as possible; then it can be passed on for recycling after being thoroughly cleaned.