Registration Dossier

Administrative data

First-aid measures

General advice: Remove contaminated clothing.
If inhaled: If difficulties occur after vapour/aerosol has been inhaled, remove to fresh air and seek medical attention.
On skin contact: Wash thoroughly with soap and water.
On contact with eyes: Immediately wash affected eyes for at least 15 minutes under running water with eyelids held open, consult an eye specialist.
On ingestion: Rinse mouth immediately and then drink plenty of water, seek medical attention.

Fire-fighting measures

Suitable extinguishing media: water, dry extinguishing media, foam, carbon dioxide
Specific hazards: harmful vapours
Evolution of fumes/fog. The substances/groups of substances mentioned can be released in case of fire.
Special protective equipment: Wear a self-contained breathing apparatus.

Accidental release measures

Personal precautions: Use personal protective clothing.
Environmental precautions: Contain contaminated water/firefighting water. Do not discharge into drains/surface waters/groundwater.
Methods for cleaning up or taking up: For large amounts: Pump off product.
For residues: Pick up with suitable absorbent material. Dispose of absorbed material in accordance with regulations.

Handling and storage

Handling
No special measures necessary provided product is used correctly.
Protection against fire and explosion:
Heated containers should be cooled to prevent polymerization. Take precautionary measures against static discharges.
Storage
Segregate from alkalies and alkalizing substances.
Further information on storage conditions: Protect against heat. Protect from the effects of light. The stabilizer is only effective in the presence of
oxygen.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all
Shippingopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Personal protective equipment
Respiratory protection: Suitable respiratory protection for higher concentrations or long-term effect: Gas filter for gases/vapours of organic
compounds (boiling point >65 °C, e. g. EN 14387 Type A)
Hand protection: Chemical resistant protective gloves (EN 374)
Suitable materials short-term contact and/or splashes (recommended: At least protective index 2, corresponding > 30 minutes of permeation time according to EN 374) butyl rubber (butyl) - 0.7 mm coating thickness nitrile rubber (NBR) - 0.4 mm coating thickness
Supplementary note: The specifications are based on tests, literature data and information of glove manufacturers or are derived from similar
substances by analogy. Due to many conditions (e.g. temperature) it must be considered, that the practical usage of a chemical-protective glove in
practice may be much shorter than the permeation time determined through testing.
Manufacturer's directions for use should be observed because of great diversity of types.
Eye protection: Safety glasses with side-shields (frame goggles) (e.g. EN 166)
General safety and hygiene measures: Handle in accordance with good industrial hygiene and safety practice. Wearing of closed work clothing is
recommended.

Stability and reactivity

Hazardous reactions:
The product can polymerize if the shelf life or storage temperature are greatly exceeded. Heat develops during polymerization. Reacts with peroxides
and other radical components.
The product is stabilized against spontaneous polymerization prior to despatch.

Disposal considerations

Must be disposed of or incinerated in accordance with local regulations.
Contaminated packaging:
Uncontaminated packaging can be re-used.
Packs that cannot be cleaned should be disposed of in the same manner as the contents