Registration Dossier

Data platform availability banner - registered substances factsheets

Please be aware that this old REACH registration data factsheet is no longer maintained; it remains frozen as of 19th May 2023.

The new ECHA CHEM database has been released by ECHA, and it now contains all REACH registration data. There are more details on the transition of ECHA's published data to ECHA CHEM here.

Diss Factsheets

Guidance on Safe Use

Guidance on Safe Use

Currently viewing:

Administrative data

First-aid measures

Eye Contact: In case of frostbite, immediately flush eyes with water; remove contact lenses, if present, after the first 5 minutes, then continue flushing eyes for at least 15 minutes. Obtain medical attention promptly, preferably from an ophthalmologist.  

Skin Contact: Immediately flush skin with plenty of water for 15 minutes. Seek medical attention.  

Inhalation: Move person to fresh air.  If not breathing, give artificial respiration; if by mouth to mouth use rescuer protection (pocket mask, etc).  If breathing is difficult, oxygen should be administered by qualified personnel.  Call a physician or transport to a medical facility.  

Ingestion: Do not induce vomiting. Call a physician and/or transport to emergency facility immediately.  In case of frostbite, immediately rinse lips and mouth with tepid water for at least 15 minutes. Obtain medical attention promptly.  

Notes to Physician: Because rapid absorption may occur through the lungs if aspirated and cause systemic effects, the decision of whether to induce vomiting or not should be made by a physician.  If lavage is performed, suggest endotracheal and/or esophageal control.  Danger from lung aspiration must be weighed against toxicity when considering emptying the stomach.  Maintain adequate ventilation and oxygenation of the patient.  Exposure may increase "myocardial irritability". Do not administer sympathomimetic drugs such as epinephrine unless absolutely necessary.  Treat for frostbite, if present.  No specific antidote.  Treatment of exposure should be directed at the control of symptoms and the clinical condition of the patient.

Fire-fighting measures

Extinguishing Media: Do not extinguish.  Stop flow of product and allow fire to burn out.  Once product flow has stopped, small fires may be extinguished with:  Water fog or fine spray.  Dry chemical fire extinguishers.  Carbon dioxide fire extinguishers.  Foam.  

Fire Fighting Procedures: Keep people away.  Isolate fire and deny unnecessary entry.  Stay upwind.  Keep out of low areas where gases (fumes) can accumulate.  Do not extinguish. If flames are accidentally extinguished, explosive re-ignition may occur.  Shut off source of fuel if possible and allow fire to burn out.  Use water spray to cool fire exposed containers and fire affected zone until fire is out and danger of reignition has passed.  Immediately withdraw all personnel from the area in case of rising sound from venting safety device or discoloration of the container.  Eliminate ignition sources.  For spills of liquefied gas, apply appropriate foam or vapor suppressing agent.  Warning!  Contact of water with liquefied gas can result in boiling, frothing, and rapid generation of vapor.  For unignited vapor cloud, use water spray to knock down and control dispersion of vapors.  

Special Protective Equipment for Firefighters: Wear positive-pressure self-contained breathing apparatus (SCBA) and protective fire fighting clothing (includes fire fighting helmet, coat, trousers, boots, and gloves).  If protective equipment is not available or not used, fight fire from a protected location or safe distance.  

Unusual Fire and Explosion Hazards: Container may vent and/or rupture due to fire.  Vapors are heavier than air and may travel a long distance and accumulate in low lying areas. Ignition and/or flash back may occur.  

Hazardous Combustion Products: During a fire, smoke may contain the original material in addition to combustion products of varying composition which may be toxic and/or irritating.  Combustion products may include and are not limited to:  Carbon monoxide.  Carbon dioxide.  

Accidental release measures

Steps to be Taken if Material is Released or Spilled: Ground and bond all containers and handling equipment.  Use fine water spray to reduce vapors.  Isolate area until gas has dispersed.  If available, use foam to smother or suppress vapors.  Apply vapor suppression foams until spill can be cleaned up.  Stop flow of gas.  Pump with explosion-proof equipment.  If available, use foam to smother or suppress.  

Personal Precautions: Evacuate area. Only trained and properly protected personnel must be involved in clean-up operations.  Keep personnel out of low areas.  Keep personnel out of confined or poorly ventilated areas.  Keep upwind of spill.  Ventilate area of leak or spill.  No smoking in area.  For large spills, warn public of downwind explosion hazard.  Check area with combustible gas detector before reentering area. Ground and bond all containers and handling equipment.  Eliminate all sources of ignition in vicinity of spill or released vapor to avoid fire or explosion.  Vapor explosion hazard.  Keep out of sewers.  Autorefrigeration potential.  Large spills of this material may plug drains and valves may become inoperable due to the formation of ice caused by expanding vapors or vaporizing liquids.  Spills of this liquefied gas may form ice, which can plug drains and can make valves inoperable.  Contact of water with liquefied gas can result in boiling, frothing, and rapid generation of vapor.  Use appropriate safety equipment.

 

Environmental Precautions: Prevent from entering into soil, ditches, sewers, waterways and/or groundwater.

Handling and storage

General Handling: Keep away from heat, sparks and flame.  Avoid contact with eyes.  Wash thoroughly after handling.  Electrically bond and ground all containers and equipment before transfer or use of material.  Avoid breathing vapor.  Keep container closed.  Use with adequate ventilation.  Do not enter confined spaces unless adequately ventilated.  Never use air pressure for transferring product.  No smoking, open flames or sources of ignition in handling and storage area.  Vapors are heavier than air and may travel a long distance and accumulate in low lying areas. Ignition and/or flash back may occur.  Ignition sources can include and are not limited to pilot lights, flames, smoking, sparks, heaters, electrical equipment, and static discharges.  Containers, even those that have been emptied, can contain vapors. Do not cut, drill, grind, weld, or perform similar operations on or near empty containers.  Use of non-sparking or explosion-proof equipment may be necessary, depending upon the type of operation.  

Storage

No smoking or open flame in storage area.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all
Shippingopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Stability and reactivity

Disposal considerations