Registration Dossier

Administrative data

First-aid measures

Description of first aid measures
· General information: Remove contaminated clothing.
· After inhalation: Supply fresh air; consult doctor in case of symptoms.
· After skin contact:
Wash with soap and water.
If skin irritation continues, consult a doctor.
· After eye contact:
Rinse opened eye for several minutes under running water. If symptoms persist, consult doctor.
· After swallowing:
Rinse out mouth and then drink plenty of water.
In case of persistent symptoms consult doctor.

Fire-fighting measures

Extinguishing media
· Suitable extinguishing agents
Carbon dioxide (CO₂), extinguishing powder or water spray/fog. Fight larger fires with water spray/fog or
alcohol-resistant foam.
· For safety reasons unsuitable extinguishing agents Water with a full water jet.
· Special hazards arising from the substance or mixture
Risk of dust explosion.
Formation of toxic gases is possible during heating or in case of fire.
Nitrogen oxides (NOx)
Carbon monoxide (CO) and Carbon dioxide (CO₂)
· Advice for firefighters
· Protective equipment: Wear self-contained breathing apparatus.
· Additional information
Cool endangered containers with water spray jet.
Dispose of fire debris and contaminated fire fighting water in accordance with official regulations.

Accidental release measures

· Personal precautions, protective equipment and emergency procedures
Ensure adequate ventilation.
Avoid causing dust.
Remove all ignition sources.
Avoid breathing dust.
Avoid contact with skin and eyes.
· Environmental precautions:
Do not allow to enter drainage system, surface or ground water.
Do not allow to enter the ground/soil.
Inform respective authorities in case product reaches water or sewage system.
· Methods and material for containment and cleaning up:
Ensure adequate ventilation.
Collect mechanically.
Dispose of the material collected according to regulations.
· Reference to other sections
See Section 8 for information on personal protection equipment.

Handling and storage

· Handling
· Precautions for safe handling
Ensure good ventilation/exhaustion at the workplace.
Any deposit of dust which cannot be avoided must be removed regularly.
Do not breathe dust.
Avoid prolonged or repeated skin contact.
Avoid contact with eyes.
Make sure that all applicable workplace limits are observed.
· Information about protection against explosions and fires:
Dust can combine with air to form an explosive mixture.
Dust explosion class: stage 1
Keep ignition sources away - Do not smoke.
Protect against electrostatic charges.
· Conditions for safe storage, including any incompatibilities
· Storage
· Requirements to be met by storerooms and containers:
Observe all local and national regulations for storage of water polluting products.
Prevent any penetration into the ground.
· Information about storage in one common storage facility: Not required.
· Further information about storage conditions:
Store in cool, dry conditions in well sealed containers.
Store container in a well ventilated position.

Transport information

Land transport (ADR/RID)

UN number:
· ADR/RID Class: -
Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

UN number:
· IMDG Class: -
Remarksopen allclose all

Air transport ICAO/IATA

UN number:
ICAO/IATA Class: -
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Control parameters
· Components with critical values that require monitoring at the workplace:
Observe all workplace limits for dust.
· Additional information: The lists that were valid during the compilation were used as basis.
Exposure controls
· Personal protective equipment
· General protective and hygienic measures
Keep away from foodstuffs, beverages and food.
Do not eat, drink or smoke while working.
Do not breathe dust.
Avoid close or long term contact with the skin.
Avoid contact with the eyes.
Wash hands during breaks and at the end of the work.
· Breathing equipment:
Use breathing protection in case of dust formation.
Dust mask
If all workplace limits are observed and good ventilation is ensured, no special precautions necessary.
· Protection of hands:
Protective gloves
To avoid skin problems reduce the wearing of gloves to the required minimum.
Check the permeability prior to each renewed use of the glove.
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation.
· Material of gloves
PVC gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer.
· Penetration time of glove material
Protective gloves should be replaced at first signs of wear.
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be
observed.
· Eye protection: Safety glasses
· Body protection: Apron

Stability and reactivity

Reactivity
· Chemical stability
· Thermal decomposition / conditions to be avoided:
Avoid impact, friction, heat, sparks, electrostatic charges.
· Possibility of hazardous reactions Risk of dust explosion.
· Incompatible materials: Strong oxidizing agents
· Hazardous decomposition products:
Nitrogen oxides (NOx)
Carbon monoxide (CO) and Carbon dioxide (CO₂)
Poisonous gases/vapours

Disposal considerations

Waste treatment methods
· Recommendation
Must not be disposed of together with household garbage. Do not allow product to reach sewage system.
Disposal must be made according to official regulations.
· European waste catalogue:
Waste disposal key numbers from EWC have to be assigned depending on origin and processing.
Uncleaned packagings:
· Recommendation: Disposal must be made according to official regulations.