Registration Dossier

Administrative data

First-aid measures

· Description of first aid measures
· General information: No special measures required.
· After inhalation: Supply fresh air; consult doctor in case of complaints.
· After skin contact: Immediately wash with water and soap and rinse thoroughly.
· After eye contact: Rinse opened eye for several minutes under running water.
· After swallowing: If symptoms persist consult doctor.
· Information for doctor:
· Most important symptoms and effects, both acute and delayed No further relevant information available.
· Indication of any immediate medical attention and special treatment needed
No further relevant information available.

Fire-fighting measures

· Extinguishing media
· Suitable extinguishing agents:
CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
· Special hazards arising from the substance or mixture No further relevant information available.
· Advice for firefighters
· Protective equipment:
Wear self-contained respiratory protective device.
Wear fully protective suit.

Accidental release measures

· Personal precautions, protective equipment and emergency procedures
Wear protective equipment specified below. Keep unprotected persons away.
· Environmental precautions: Do not allow to enter sewers/ surface or ground water.
· Methods and material for containment and cleaning up:
Pick up mechanically.
Dispose contaminated material as waste according to official regulations

Handling and storage

· Handling:
· Precautions for safe handling Prevent formation of dust.
· Information about fire - and explosion protection:
Dust can combine with air to form an explosive mixture.
Protect against electrostatic charges.
· Conditions for safe storage, including any incompatibilities
· Storage:
· Requirements to be met by storerooms and receptacles: No special requirements.
· Information about storage in one common storage facility: Not required.
· Further information about storage conditions: Protect from heat and direct sunlight.
· Specific end use(s) No further relevant information available.

Transport information

Land transport (ADR/RID)

UN number:
This product is not regulated for carriage according to ADR/RID,IMDG,ICAO/IATA.
Shippingopen allclose all
SpecialProvisionsopen allclose all

Inland waterway transport (ADN(R))

UN number:
This product is not regulated for carriage according to ADR/RID,IMDG,ICAO/IATA.
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

UN number:
This product is not regulated for carriage according to ADR/RID,IMDG,ICAO/IATA.
Remarksopen allclose all

Air transport ICAO/IATA

UN number:
This product is not regulated for carriage according to ADR/RID,IMDG,ICAO/IATA.
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

· Additional information about design of technical facilities: No further data; see Handling and storage
· Control parameters
· Ingredients with limit values that require monitoring at the workplace:
Total inhalable dust: 4 mg/m3 (MAK-Vf)
Respirable dust: 1.5 mg/m3 (MAK-Vf)
· Additional information: The lists valid during the making were used as basis.
· Exposure controls
· Personal protective equipment:
· General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
· Respiratory protection: Use suitable respiratory protective device in case of insufficient ventilation.
· Protection of hands:
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
· Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
· Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
· Eye protection: Safety glasses

Stability and reactivity

· Reactivity
· Chemical stability
· Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications.
· Possibility of hazardous reactions Risk of dust explosion.
· Conditions to avoid No further relevant information available.
· Incompatible materials: No further relevant information available.
· Hazardous decomposition products: No dangerous decomposition products known.

Disposal considerations

· Waste treatment methods
· Recommendation Must be specially treated adhering to official regulations.
· Uncleaned packaging:
· Recommendation: Disposal must be made according to official regulations.