Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 221-338-7 | CAS number: 3069-40-7
Testing for toxicity to terrestrial organisms is not considered necessary because:
The hydrolysis half-life of the registration substance is approximately 4 hours at neutral pH therefore the hazard assessment for the terrestrial compartments is based on the silanol hydrolysis product.
In accordance with Column 2 of REACH Annex IX, there is no need to further investigate the effects of the silanol hydrolysis product in a short- or long-term terrestrial toxicity to invertebrates/higher plants study because, as indicated in guidance R.7.11.6 (ECHA 2016), the quantitative chemical safety assessment (conducted according to Annex I of REACH) indicates that the Risk Characterisation Ratio is below 1, and therefore the risk is already adequately controlled and further testing is not justifiable.
The substance is used under highly controlled conditions and, therefore, exposure of soil is low.
The silanol hydrolysis product is not readily biodegradable but has low potential for bioaccumulation and low bioavailability (based on log Kow <3 (1.1)), and there is no reason to expect any specific mechanism of toxicity beyond narcosis.
Long-term toxicity testing to aquatic invertebrates has been carried out with a structural analogue of the registered substance. During this test, it is likely that organisms were exposed to the hydrolysis products of the test substance. The occurrence of more severe toxic effects in the terrestrial compartment that were not expressed in this aquatic study (conducted at concentrations up to 100 mg/L (nominal)) would be considered unlikely.
The PNEC calculated by Equilibrium Partitioning has been derived for the purpose of chemical safety assessment and the risk characterisation ratios are below 1.
Overall it is concluded that the risk characterisation conclusion is sufficiently conservative in respect of any uncertainties and therefore further testing is not considered necessary.
Details on how the PNEC and the risk characterisation ratio have been derived can be found in IUCLID Section 6.0 and Chapters 9 and 10 of the Chemical Safety Report respectively.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
Welcome to the ECHA website. This site is not fully supported in Internet Explorer 7 (and earlier versions). Please upgrade your Internet Explorer to a newer version.
Close Do not show this message again