Registration Dossier

Administrative data

First-aid measures

Emergency measure - Inhalation: Remove from exposure area and keep at rest. Seek medical
advice.
Emergency measure - Eyes: Immediately flush eyes with plenty of water for 15 minutes
if contact occurs. It is also recommended that a medical
check is performed.
Emergency measure - Skin: It is recommended that hands and arms are washed with soap
and water. If extensive skin contact occurs, remove
contaminated clothing and wash contacted skin with soap and
water. In the unlikely event that irritation occurs seek
medical advice.
Emergency measure - Ingestion: Seek immediate medical advice.

Fire-fighting measures

Recommended extinguishing agent: Water, water foam, dry powder or carbon dioxide
extinguishers should be used.

Product arising from burning: The substance is a flame retardant and therefore not
anticipated to be combustible when involved in a fire.
However particulates may be present in smoke and vapour if
involved in a fire. However, there is no experimental
evidence to support this.

Product determined by test: N

Protective equipment: Full protective clothing and self-contained breathing
apparatus must be worn.

Accidental release measures

Emergency measures in case of spillage: Evacuate personnel from immediate vicinity.


Wear appropriate personal protective equipment conforming to
the relevant national or international standards as
mentioned in section 2.3.10.


Small spills can be washed to drain with copious amounts of
water.


Large spillages should be mixed with a suitable inert
material (eg sand or soil). Carefully transfer the spillage
to waste containers, or use a sealed industrial vacuum
machine. Containers filled with waste material must be
labelled in the same way as the original containers.



Clean the spillage area with water and discharge to drain
with large quantities of water.



Dispose of waste material in accordance with local
regulations.

Handling and storage

Handling: The substance should be stored, handled and used in
conditions of good industrial hygiene and in conformity with
any local regulations in order to avoid exposure.


Engineering controls are necessary to reduce exposure to the
substance.


When exposure cannot be prevented or adequately controlled
appropriate personal protective equipment should be worn.
Such protective equipment should conform to the appropriate
international or national standards as follows;

Chemical protective gloves to Standard EN374

Chemical resistant clothing to Standard EN368

Eye protection to Standard EN166


When necessary appropriate respiratory protection should be
used. e.g. a dust mask conforming to EN149 FFP1.


The standards mentioned above should be regarded as a
minimum.

Storage: Store in a cool, dry, well-ventilated area out of direct
sunlight.


Keep containers tightly closed when not in use.


The material should be protected against moisture i.e. in a
closed system.

Packaging of the substance and or preparation: Packaged in welded polyethylene bags, enclosed in paper bags
or metal drums.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all

Air transport ICAO/IATA

Remarks
Transport code: None
Transport: Observe and show where possible the labels on the
containers. Avoid damaging the containers.
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Stability and reactivity

Danger other than fire: None reported.

Chemical reaction with water: None reported.

Dust explosion: Not anticipated.

Dust explosion determined by test: N

Disposal considerations

Industry - Possibility of recovery/recycling: Discharge to the environment will be minimal. Recovery from
minor spillages or accidental discharge is not economically
or technically feasible, and such waste material will be
disposed of by incineration or landfill. In principle, it
may be possible to recover larger spillages of
uncontaminated material for subsequent use.

Industry - Possibility of neutralisation: The notification tests have shown that the substance is not
considered hazardous to health. No chemical methods are
avaiable to neutrsalise any environmental effects.

Industry - Possibility of destruction: controlled discharge: Contaminated containers or spillages of solutions mixed with
inert material (eg sand or soil) may be disposed of by
landfill at an authorised tip in accordance with local
regulations.

Industry - Possibility of destruction - incineration: The substance can be disposed of by incineration by burning
under controlled conditions at a licensed waste treatment
processor in accordance with local regulations. Stack gases
should be scrubbed, because noxious fumes (eg carbon,
nitrogen and phosphorus oxides)could be formed.

Industry - Possibility of destruction - water purification: The substance may be discharged directly to the sewage
system or the aqueous environment. However any release to
the water purification system is unlikely to have adverse
effects.

Public at large - Possibility of recovery/recycling: Not Applicable.

Public at large - Possibility of neutralisation: None

Public at large - Possibility of destruction: controlled discharge: Not applicable.

Public at large - Possibility of destruction - incineration: Not applicable.

Public at large - Possibility of destruction - water purification: The substance has been shown not to be harmful to water
purification systems.