Registration Dossier

Administrative data

First-aid measures

-General information
Remove contaminated soaked cloting immdiately and dispose of safely.
In event of symptom refer for medical treament.
-Skin contact
In the case of contact with skin wash off immediately with plenty of water.
-Eye conact
In case of contact with eyes rinse thoroughly with plenty of water and seek medical advice.
-Ingestion
Do not induce vomiting.
Summon a doctor immediatly.
-Advice to doctor
If swallowed or in the vent of vomiting, risk of product entering the lungs.
If swallowed, stomach should be pumped out under adition of Dimeticon.

Fire-fighting measures

Suitable extinguishing media
water (not water jet)
alcohol-resistant foam
dry powder
carbon dioxide
Special haards arising from te substance or mixture
In the event of fire the following can be released:
Nitrogen oxides (NOx)
Sulphurous oxides (SOx)
Special protective equipement
Short term: filter apparatus, combination filter
Do not inhale explosion and/or combustion gases.

Accidental release measures

-Personal precautions
Avoid contact with eyes and skin.
-Environmental precautions
Do not discharge into th rains/surface water/groundwaters.
-Methods for cleaning up/taking up
Take up with absorbent material.
e.g. general purpose-binder
Dispose of absorbed material in accordance with the regulations.

Handling and storage

-Advice on safe handling
No special measures necessary, check MSDS for more information
-Advice on protecion against fir eand explosion
No special measures necessary.
-Requirements for storag rooms ad vessels
No special measures necessary.
-Further information on storage conditions
Protect from frost.
Do not keep at temperatures above 50°C for a long time

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

PERSONAL PROTECTIVE EQUIPMENT Respiratory protection: No personal respiratory protective equipment normally required. In inadequately ventilated areas, where workplace limits are exceeded, where unpleasant odours exist or where aerosols are in use, or smoke and mist occur, use self-contained breathing apparatus or breathing apparatus with a combined filter (e.g. A-P2 or ABEK-P2), in compliance with EN 141. Hand protection: The choice of an appropriate glove does not only depend on its material but also on other quality features and is different from one producer to the other., Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion, and the contact time., Be aware that in daily use the durability of a chemical resistant protective glove can be notably shorter than the break through time measured according to EN 374, due to the numerous outside influences (e.g. temperature).gloves suitable for permanent contact:Material: butyl-rubber;Break through time: >= 480 min;Material thickness: >= 0.7 mmgloves suitable for splash protection:Material: Nitrile rubber/nitrile latex;Break through time: >= 30 min;Material thickness: >= 0.4 mmEye protection: Tightly fitting safety goggles Skin and body protection: Protective suit Hygiene measures: Handle in accordance with good industrial hygiene and safety practice. Keep away from food, drink and animal feedingstuffs. Wear suitable gloves and eye/face protection. Protective measures: Wear suitable gloves and eye/face protection. Avoid contact with the skin and the eyes.

Stability and reactivity

Conditions to avoid: Avoid temperatures above 50°C, direct sunlight and contact with sources of heat. Hazardous decomposition products: diluted sulfuric acidThermal decomposition: Decomposes on heating.

Disposal considerations

Product: Can be incinerated, when in compliance with local regulations.