Registration Dossier

Administrative data

First-aid measures

General advice: Take off contaminated clothing and shoes immediately. Victim to lie down in the recovery position, cover and keep him warm. Call a physician immediately.
If inhaled: Oxygen or artificial respiration if needed.
In case of skin contact: Wash off immediately with soap and plenty of water.
In case of eye contact: Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Call a physician immediately.
If swallowed: Drink plenty of water. Prevent vomiting if possible.

Fire-fighting measures

Suitable extinguishing media: Water spray jet, Foam, Dry powder
Unsuitable extinguishing media: High volume water jet
Specific hazards during firefighting: Fire may cause evolution of: Carbon monoxide (CO) Carbon dioxide (CO2)
When extinguishing with water pay attention to caustic burns.
Vapour/air-mixtures are explosive at intense warming.
Vapours are heavier than air and may spread along floors.
Further information: Prevent fire extinguishing water from contaminating surface water or the ground water system.
Special protective equipment for firefighters: In the event of fire, wear self-contained breathing apparatus. Use personal protective equipment.

Accidental release measures

Personal Precautions:
Use personal protective equipment.
Enviromental Precautions:
Do not flush into surface water or sanitary sewer system.
Methods for cleaning or taking up:
Cover spilt product with liqiud-binding material (sand, silica gel, acid binder, universal binder, hybilat). Take up mechanically and fill into labelled, closed containers.
Further accidental release measures:
Keep away from/remove sources of ignition.

Handling and storage

Handling:
Avoid formation of aerosol. Only handle product with local exhaust ventilation. Avoid contact with skin, eyes and clothing.
Keep away from open flames, hot surfaces and sources of ignition. Take measures to prevent the build up of electrostatic charge.
Conditions for safe storage, including any incompatibilities
For storage suitable stores with adequate product-reception volume must be used. During handling local official regulations must be observed in order to avert impairment of water by the product.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all
Shippingopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Personal protective equipment
Respiratory protection: full mask with filter A
Eye protection: safety glasses with side-shields
Hand protection: During the handling of the substance according to the intended use protection gloves from nitrile rubber have been proved. During the handling of pure solid substances or powder mixtures a permeation of the rubber material is not to be expected. In case of doubt, especially
during handling of the substance together with organic solvents, the stability of the protection gloves has to be clarified with the manufacturer.
Skin and body protection: Choose body protection according to the amount and concentration of the dangerous substance at the work place.

Stability and reactivity

Condition to avoid: Heat, Exposure to moisture
Materials to avoid: Water, Strong acids and oxidization agents, Strong bases, Reducing agents
Hazardous reactions with: Water, Strong acids and oxidization agents, Strong bases, Reducing agents

Disposal considerations

Product: Dispose of as special waste in compliance with local and national regulations