Registration Dossier

Administrative data

First-aid measures

Description of first aid measures
General information:
In case of accident or if you feel unwell seek medical advice (show label or SDS where possible).
After contact with the eyes:
Rinse immediately with plenty of water. Seek medical advice in case of continuous irritation.
After contact with the skin:
Wash with plenty of water or water and soap. In the event of a visible skin change or other complaints, seek medical advice (show
label or SDS where possible).
After inhalation:
Provide fresh air.
After swallowing:
Give several small portions of water to drink. Do not induce vomiting.
Most important symptoms and effects, both acute and delayed
Any relevant information can be found in other parts of this section.
Indication of any immediate medical attention and special treatment needed
Further toxicology information must be observed.

Fire-fighting measures

Extinguishing media
Suitable extinguishing media:
extinguishing powder , sand , alcohol-resistant foam , carbon dioxide .
Extinguishing media which must not be used for safety reasons:
water jet , water spray .
Special hazards arising from the substance or mixture
none known
Advice for firefighters
Special protective equipment for fire fighting:
Use respiratory protection independent of recirculated air.

Accidental release measures

Personal precautions, protective equipment and emergency procedures
If material is released indicate risk of slipping.
Environmental precautions
Prevent material from entering sewers or surface waters. Contain any fluid that runs out using suitable material (e.g. earth).
Methods and material for containment and cleaning up
Absorb with a liquid binding material such as diatomaceous earth and dispose of according to local/state/federal regulations. Do
not flush away with water. Collect into sealed containers.
Further information:
Eliminate all sources of ignition.
Reference to other sections
Relevant information in other sections has to be considered. This applies in particular for information given on personal protective
equipment and on disposal.

Handling and storage

Precautions for safe handling
Precautions for safe handling:
Spilled substance increases risk of slipping.
Precautions against fire and explosion:
Keep away from sources of ignition and do not smoke. Cool endangered containers with water.
Conditions for safe storage, including any incompatibilities
Conditions for storage rooms and vessels:
Store in a cool place.
Advice for storage of incompatible materials:
Observe local/state/federal regulations.
Further information for storage:
Store cool. Keep container tightly closed.

Transport information

Land transport (ADR/RID)

UN number:
Not regulated for transport
Shippingopen allclose all
SpecialProvisionsopen allclose all

Inland waterway transport (ADN(R))

UN number:
Not regulated for transport
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

UN number:
Not regulated for transport
Remarksopen allclose all

Air transport ICAO/IATA

UN number:
Not regulated for transport
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Control parameters
Maximum airborne concentrations at the workplace: Aerosol - inhalable fraction 10,0 mg/m3.
The aerosol limit specified is a recommendation should aerosol be formed during processing.
Exposure controls
Exposure in the work place limited and controlled
General protection and hygiene measures:
Do not eat, drink or smoke when handling. Do not breathe vapours.
Personal protection equipment:
Respiratory protection
In accordance with instructions: not required .
Eye protection
Recommendation: protective goggles .
Hand protection
Recommendation: Protective gloves made of butyl rubber . The selection of appropriate gloves not only depends on the material,
but also on other quality characteristics, and may vary depending on the manufacturer. Please observe information from your
glove supplier in terms of permeability and breakthrough time.
Exposure to the environment limited and controlled
Prevent material from entering surface waters and soil.

Stability and reactivity

Reactivity; Chemical stability; Possibility of hazardous reactions
If stored and handled in accordance with standard industrial practices no hazardous reactions are known.
Relevant information can possibly be found in other parts of this section.
Conditions to avoid
Heat, open flames, and other sources of ignition.
Incompatible materials
none known
Hazardous decomposition products
If stored and handled properly: none known .

Disposal considerations

Waste treatment methods
Material
Recommendation:
Dispose of according to regulations by incineration in a special waste incinerator. Observe local/state/federal regulations.
Uncleaned packaging
Recommendation:
Completely discharge containers (no tear drops, no powder rest, scraped carefully). Containers may be recycled or re-used.
Observe local/state/federal regulations.
Waste Disposal Legislation Ref.No.(EC)
It is not possible to determine a waste code for this product in accordance with the European Waste Catalogue (EWC) since it is
only possible to classify it according to how it is used by the customer. The waste code is to be determined within the EU in liaison
with the waste-disposal operator.