Registration Dossier

Administrative data

First-aid measures

General advice : Seek medical assistance if discomfort continues
Ensure that the First Aid Personnel are aware of the product involved, and take precautions to protect themselves (e.g. wear personal protection
equipment). Remove from exposure, lie down.
If inhaled : Remove the casualty into fresh air and keep him calm.
In case of skin contact : In case of contact with skin, clean with soap and water.
In case of eye contact : Rinse the affected eye with plenty of water, at the same time keep the unaffected eye well protected. If easy to do,
remove contact lens, if worn.
Ingestion is not a considered route of exposure.
If accidentially swallowed : Rinse mouth with water. Seek medical advice immediately and show safety data sheet or label.

Fire-fighting measures

The product itself does not burn. Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

Specific hazards during firefighting: In case of fires, hazardous combustion gases can be formed, as Carbon monoxide (CO)
Carbon dioxide (CO2). Under certain conditions of combustion traces of other toxic substances cannot be excluded.

Special protective equipment for firefighters: In case of fire and if needed use self-contained breathing apparatus

Further information : Fire residues and contaminated firefighting water must be disposed of in accordance with the local regulations.

Accidental release measures

Personal precautions : Wear personal protective equipment. Unprotected persons must be kept away.
Avoid contact with skin and eyes. Avoid breathing dust. Avoid dust formation.

Environmental precautions : Do not allow entry to drains,water courses or soil. Contain contaminated water/firefighting water.

Methods for cleaning up : Contain spillage, and then collect with an electrically protected vacuum cleaner or by wet-brushing
and place in container for disposal according to local regulations.

Handling and storage

Advice on safe handling : The product should be handled under strictly controlled conditions as defined in Article 18 (4) REACH.
Avoid the formation and deposition of dust.

Advice on protection against fire and explosion : Dust might form an explosive mixture with air. Take measures to prevent the build up of
electrostatic charge. Keep away from sources of ignition - refrain from smoking. Observe the general rules of industrial fire protection.

Requirements for storage areas and containers : Store in original container. Keep containers tightly closed in a dry, cool and wellventilated
place. Keep away from food, drink and animal feedingstuffs.

Transport information

Land transport (ADR/RID)

UN number:
Not classified
Shippingopen allclose all
SpecialProvisionsopen allclose all

Inland waterway transport (ADN(R))

UN number:
Not classified
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

UN number:
Not classified
Remarksopen allclose all

Air transport ICAO/IATA

UN number:
Not classified
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Engineering measures : Product should be worked up in closed equipment as far as possible. Dust must be extracted directly at the point of origin.

Respiratory protection : In case of dust formation, use a fine dust face mask.

Hand protection : Nitrile rubber gloves. Butyl rubber gloves. With solid dry substances permeation is not to be expected, therefore the breakthrough-time for this protective glove has not been measured. The suitability for a specific workplace should be discussed with the producers of the protective gloves.

Eye protection : Tightly fitting safety goggles according to EN 163.

Skin and body protection : Long sleeved clothing. Wear as appropriate: Protective clothing Category III, type 5 - Particle-tight, Disposable suit

Hygiene measures : Handle in accordance with good industrial hygiene and safety practice. Do not eat, drink or smoke during work time.
Remove soiled or soaked clothing immediately and clean thoroughly before using again. Garments that cannot be cleaned must be destroyed (burnt). Clean hands and face during work intervals and after work. Use barrier skin cream. Follow the skin protection plan.

Protective measures : Do not inhale dust. The type of protective equipment must be selected according to the concentration and amount of the dangerous substance at the specific workplace.

Environmental exposure controls

General advice : Do not allow entry to drains,water courses or soil. Contain contaminated water/firefighting water.

Stability and reactivity

The product is thermally and chemically stable. No dangereous reactions or incompatible materials are known so far. Generally with solid organic substances, which - intentionally or not - are powdered, the risk of dust explosion must be kept in mind.

Disposal considerations

Waste treatment methods:

Product : Special waste incineration plant, after consultation with operators. Observe local authority regulations.

Contaminated packaging : Packaging that cannot be cleaned should be disposed of as product waste. For disposal local regulation is binding.