Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 263-467-1 | CAS number: 62229-08-7
This study assessed the in vitro absorption of lead oxide in human skin samples at 0, 111, and 1033 ug/cm2 concentrations over 24 hours. For the 111 ug/cm2 dose, 95.63% of the applied lead was removed during the wash at 6 hours post-exposure. At 24 hours post-exposure, 99.51% of the applied dose was not absorbed. The absorbed dose into the receptor fluid was <0.01% (5 ng/cm2) and the dermal delivery was 0.13% (148 mg/cm2) of the applied dose. For the 1033 ug/cm2 dose, 96.10% of the applied lead was removed during the wash at 6 hours post-exposure. At 24 hours post-exposure, 98.28% of the applied dose was not absorbed. The absorbed dose was <0.01% (10 ng/cm2) and the dermal delivery was 0.05% (479 ng/cm2) of the applied dose. The authors concluded that the apparent decrease in absorption as a function of dose may be attributable to the considerable background from endogenous lead in the donor skin restricting the reliability of the absorption factor at the low dose.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
Welcome to the ECHA website. This site is not fully supported in Internet Explorer 7 (and earlier versions). Please upgrade your Internet Explorer to a newer version.
Close Do not show this message again