Registration Dossier
Registration Dossier
Diss Factsheets
Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 239-802-2 | CAS number: 15708-41-5
- Life Cycle description
- Uses advised against
- Endpoint summary
- Appearance / physical state / colour
- Melting point / freezing point
- Boiling point
- Density
- Particle size distribution (Granulometry)
- Vapour pressure
- Partition coefficient
- Water solubility
- Solubility in organic solvents / fat solubility
- Surface tension
- Flash point
- Auto flammability
- Flammability
- Explosiveness
- Oxidising properties
- Oxidation reduction potential
- Stability in organic solvents and identity of relevant degradation products
- Storage stability and reactivity towards container material
- Stability: thermal, sunlight, metals
- pH
- Dissociation constant
- Viscosity
- Additional physico-chemical information
- Additional physico-chemical properties of nanomaterials
- Nanomaterial agglomeration / aggregation
- Nanomaterial crystalline phase
- Nanomaterial crystallite and grain size
- Nanomaterial aspect ratio / shape
- Nanomaterial specific surface area
- Nanomaterial Zeta potential
- Nanomaterial surface chemistry
- Nanomaterial dustiness
- Nanomaterial porosity
- Nanomaterial pour density
- Nanomaterial photocatalytic activity
- Nanomaterial radical formation potential
- Nanomaterial catalytic activity
- Endpoint summary
- Stability
- Biodegradation
- Bioaccumulation
- Transport and distribution
- Environmental data
- Additional information on environmental fate and behaviour
- Ecotoxicological Summary
- Aquatic toxicity
- Endpoint summary
- Short-term toxicity to fish
- Long-term toxicity to fish
- Short-term toxicity to aquatic invertebrates
- Long-term toxicity to aquatic invertebrates
- Toxicity to aquatic algae and cyanobacteria
- Toxicity to aquatic plants other than algae
- Toxicity to microorganisms
- Endocrine disrupter testing in aquatic vertebrates – in vivo
- Toxicity to other aquatic organisms
- Sediment toxicity
- Terrestrial toxicity
- Biological effects monitoring
- Biotransformation and kinetics
- Additional ecotoxological information
- Toxicological Summary
- Toxicokinetics, metabolism and distribution
- Acute Toxicity
- Irritation / corrosion
- Sensitisation
- Repeated dose toxicity
- Genetic toxicity
- Carcinogenicity
- Toxicity to reproduction
- Specific investigations
- Exposure related observations in humans
- Toxic effects on livestock and pets
- Additional toxicological data

Endpoint summary
Administrative data
Description of key information
Additional information
Due to the ionic structure under environmental relevant pH conditions, no adsorption onto the organic fraction of soils or sediments is expected. An adsorption/desorption screening test is therefore waived. Available data for EDTA and its salts as mentioned in the EU RAR for EDTA (CAS 60 -00 -4, see IUCLID section 13 for read-across justification) is summarized below.
In a laboratory test, the mobility of EDTA in soil was tested. Solutions of H4EDTA and ZnEDTA were eluted through cores of two various surface soils. H4EDTA was found to be very slightly adsorbed and moved quite readily through both soils. The EDTA from ZnEDTA also moved readily, however, the Zn was replaced by Fe to a large extent (Cheng et al., 1972).
The influence of EDTA on the sorption of Zn onto soils was tested by Elrashidi and O'Connor (1982). The presence of EDTA in the soil suspension significantly decreased the Zn sorption on 3 investigated soils. Only a slight difference in Zn sorption was observed whether EDTA was added to the Zn containing soil before or after contact with soil.
Similar effects were found with Cd, the adsorption is significantly reduced (Elliott and Denneny, 1982; Fuji, 1978).
A model calculation of the distribution of EDTA metal complexes between water and suspended solids resulted that <1% of the total EDTA is adsorbed. The parameters should be valid for the Swiss river Glatt: with an EDTA concentration 30 μg/l and a suspended matter concentration of 10 mg/l, only EDTA metal complexes can adsorb (Kari, 1994).
In an experiment, the distribution between water and sediment of the Swiss river Glatt was estimated for 3 different EDTA metal complexes. The EDTA concentration was measured in the water phase, from this the partition coefficients were calculated: 3 l.kg-1 for CaEDTA, 38 l.kg-1 for ZnEDTA, and 113 l.kg-1 for CuEDTA. For the real conditions of the river Glatt, the adsorbed part of the total EDTA content should generally range below 0.1% (Kari, 1994).
For the exposure calculation, values for Kpsoil, Kpsed and Kpsusp of 75 l.kg-1 are used. This is the average value between Zn- and CuEDTA, CaEDTA is not expected in most surface waters (see Section 3.1.3.3).
Based on the physico-chemical properties of H4EDTA, a calculation with the fugacity model Mackay level I predicts that the hydrosphere is the preferred environmental compartment (99.999%).
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.
Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
