Registration Dossier

Data platform availability banner - registered substances factsheets

Please be aware that this old REACH registration data factsheet is no longer maintained; it remains frozen as of 19th May 2023.

The new ECHA CHEM database has been released by ECHA, and it now contains all REACH registration data. There are more details on the transition of ECHA's published data to ECHA CHEM here.

Diss Factsheets

Environmental fate & pathways

Endpoint summary

Administrative data

Description of key information

Additional information

Sediment partition coefficients were measured for the commercial phthalate esters, disodecyl phthalate (DIDP) and ditridecyl phthalate (DTDP). The experimental procedure was based on the U.S. Environmental Protection Agency (EPA) Test Guideline 796.2750, “Sediment and Soil Adsorption Isotherm.” Three sediments were used: EPA 8 (0.15% organic carbon), EPA 18 (0.66% organic carbon), and EPA 21 (1.88% organic carbon). The Freundlich equation was used to calculate organic carbon-normalized sediment/water partition coefficients (Koc), which averaged 2.86 E5 and 1.20 E6 for DIDP and DTDP, respectively. By interpolation, the Koc of DIUP is estimated as approximately 6.0 E5. In general, these Koc values did not correlate well to either sediment or chemical properties. This lack of correlation suggested that the measured Koc values are suppressed, potentially as a function of experimental conditions. On the basis of these data, it was decided to investigate the dependence of Koc on sediment solids concentration and dissolved organic carbon. Analysis of these and earlier reported partition coefficient data indicated that measured Koc values for phthalate esters obtained in shake-flask experiments exhibited an inverse dependence on solids concentration. These results were consistent with partitioning models that are discussed. Depending on compound hydrophobicity, the particle-corrected Koc values were from one to three orders of magnitude higher than the measured Koc values. Therefore, if partition coefficient values obtained by using Test Guideline 796.2750 or similar shake-flask procedures are not corrected for solids effect, the estimates of the sediment pore-water concentration of the chemical is likely to be overestimated.

DIUP vapor pressure is very low, 0.000000497 Pa, which suggests very limited volatilization from the terrestrial compartment. In comparison, Henry's Law constant for DIUP, 50.5 Pa.m3/mole at 25 degrees C, indicates that volatilization from water is not expected to occur at a rapid rate, but may occur at a significant rate. DIUP can volatilize to air from aqueous environments at a significant rate, but is expected to have limited volatilization from soil.