Registration Dossier

Administrative data

First-aid measures

General advice: No hazards which require special first aid measures.
Inhalation: Remove from exposure, lie down. If breathing is irregular or stopped, administer artificial respiration. Monitor breathing,
give oxygen if necessary. Consult a physician.
Ingestion:Consult a physician. Do not induce vomiting without medical advice. Never give anything by mouth to an unconscious
person.

Fire-fighting measures

Suitable extinguishing media: Foam, Dry powder, Carbon dioxide (CO2)
Extinguishing media which shall not be used for safety reasons: High volume water jet
Further information: Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

Accidental release measures

Personal precautions: Avoid dust formation.
Methods for cleaning up: Use mechanical handling equipment.

Handling and storage

HANDLING
Safe handling advice Avoid dust formation.
Advice on protection against fire and explosion Normal measures for preventive fire protection.
STORAGE
Requirements for storage areas and containers: Keep tightly closed. Keep in a dry place.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Additional transport information

Additional information
Special provisions / remarks / other:
No dangerous good

Exposure controls / personal protection

ENGINEERING MEASURES
In case of dust being formed, provide for adequate extraction.
PERSONAL PROTECTIVE EQUIPMENT
Respiratory protection: No personal respiratory protective equipment normally required. In inadequately ventilated areas, where
workplace limits are exceeded, where unpleasant odours exist or where dust, fibres and smoke occur, use self-contained
breathing apparatus or breathing apparatus with a type P2 or P3 filter, in compliance with EN 143.
Hand protection: The choice of an appropriate glove does not only depend on its material but also on other quality features and is
different from one producer to the other., Please observe the instructions regarding permeability and breakthrough time which are
provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used,
such as the danger of cuts, abrasion, and the contact time., Be aware that in daily use the durability of a chemical resistant
protective glove can be notably shorter than the break through time measured according to EN 374, due to the numerous outside influences (e.g. temperature).
gloves suitable for permanent contact:material: Nitrile rubber/nitrile latex;Break through time: >= 480 min;Material thickness: 0.35 mm
Material: butyl-rubber;Break through time: >= 480 min;Material thickness: 0.5 mm
Eye protection:Safety glasses
Hygiene measures: Do not breathe dust or spray mist. Use barrier cream regularly.

Stability and reactivity

Thermal decomposition: No decomposition if used as directed.
Hazardous reactions: None known.

Disposal considerations

Product: Can be disposed of as a solid waste or burned in a suitable installation subject to local regulations.