Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 431-620-3
CAS number: 162537-11-3
Emergency measure - Inhalation: Remove to fresh air. If person is not breathing give
artifical respiration. If breathing is difficult administer
oxygen. Seek immediate medical attention.
Emergency measure - Eyes: Hold eyelids apart and flush with plenty of water for 15 minutes. Seek immediate medical attention.
Emergency measure - Skin: Remove contaminated clothing. Wash skin with plenty of soap and water. Launder contaminated clothing before re-use. Seek
immediate medical attention.
Emergency measure - Ingestion: Vomiting may be induced if a person is conscious and not experiencing convulsions. Never give anything by mouth to an
unconscious person. Seek immediate medical attention.
Recommended extinguishing agent: Water spray, carbon dioxide, dry chemical foam and powder.
Product arising from burning: Hazardous decomposition products may consist of carbon and
nitrogen oxides. However, there is no experimental evidence
to support the anticipated combustion products.
Product determined by test: N
Protective equipment: Full chemical and flame resistant protective clothing
gloves, boots and self-contained breathing apparatus must be
Fight the fire from a safe distance or protected location.
Emergency measures in case of spillage: Evacuate personnel from immediate vicinity.
Wear appropriate personal protective equipment conforming to
the relevant national or international standards, as
mentioned in section 2.3.10. At a minimum PPE consisting of
coverall, shoe covers, eye protection, impermeable gloves and a respirator with high efficency filters or cartridges
must be used.
Minimise dust formation by damping down with water. Absorb
spillages of solutions with a suitable inert material (eg.
sand or soil). Carefully transfer the spillage to waste
containers, or use a wet/dry HEPA vacuum. Containers filled with waste material must be labelled in the same way as the
original substance containers.
Clean the spillage area with water and detergent and ventilate the area.
Dispose of waste material in accordance with local
Handling: The substance should be stored, handled and used under
conditions of good industrial hygiene and in conformity with
any local regulations in order to prevent exposure to the
extent technically feasible.
Engineering controls in the form of LEV are necessary to
reduce exposure to the substance.
When exposure cannot be prevented or adequately controlled
appropriate personal protective equipment must be worn.
Such protective equipment must conform to the appropriate
international or national standards as follows;
Chemical protective gloves to Standard EN374
Chemical protective clothing to Standard EN368
Eye protection to Standard EN166.
Respiratory protective equipment. eg. a respirator
conforming to EN136.
Gloves should be changed regulary and removed after overt
contamination. Rubber, neoprene or other gloves may be
required if solvents, corrosives or other chemicals are
These measures mentioned above are regarded as a minimum,
and must be conformed with.
Storage: Store in a dark dry area, away from heat and sunlight.
Keep containers tightly closed when not in use. Ensure
containers are properly labelled
Packaging of the substance and or preparation: Material is packaged in UN approved fibre drums.
Danger other than fire: None known.
Chemical reaction with water: None which is hazardous.
Dust explosion: Material exhibits strong explosion characteristics if
ignited as a dust cloud. Material is highly susceptible to
accumulating static charges during processing and
uncontrolled static discharge may result in igniting a dust
cloud under certain conditions due to the low minimum
ignition energy. Provide suitable bonding and grounding for
containers and process equipment to control static charges.
Powder handling equipment such as dust collectors, dryers,
and mills may require additional protective measures (eg.
Dust explosion determined by test: Y
Discharge to the environment will be minimal. Recovery from
minor spillages or accidental discharge is not economically
or technically feasible, and such waste material will be disposed of off-site by closed cycle incineration. Recovery
of larger spillages of uncontaminated material for
subsequent use is recommended. As material is used in the process, no recycling of material is possible. The substance can be disposed of by incineration by burning
under controlled conditions at a licensed waste treatment
processor using a closed-cycle incinerator with scrubbers in accordance with local and national regulations.
. The substance should not be discharged directly to the
sewage system or the aqueous environment but trace quantities
in aqueous washes can be treated in secondary biological WWTP before discharge to municipal treatment works.
Trace quantities are destroyed by biological oxidation in waste water treatment plants.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
Questo sito web si avvale di cookie affinché possiate usufruire della migliore esperienza sui nostri siti web.
Welcome to the ECHA website. This site is not fully supported in Internet Explorer 7 (and earlier versions). Please upgrade your Internet Explorer to a newer version.
Do not show this message again