Registration Dossier

Administrative data

First-aid measures

After inhalation
. Supply fresh air.
. Seek medical treatment.

After skin contact
. Instantly wash with water and soap and rinse thoroughly.
. Seek medical treatment.

After eye contact
. Rinse opened eye for several minutes under running water.
. Seek medical treatment.

After swallowing
. Attention, danger of aspiration!
. Rinse out mouth and then drink plenty of water.
. Do not induce vomiting; instantly call for medical help.

Most important symptoms and effects, both acute and delayed
. No further relevant information available.

Information for doctor
. Therapeutically measures: basic help, decontamination, symptomatic treatment.

Indication of any immediate medical attention and special treatment needed
. No further relevant information available.
*

Fire-fighting measures

Extinguishing media
Suitable extinguishing agents
. CO2, extinguishing powder or water jet. Fight larger fire with foam.

For safety reasons unsuitable extinguishing agents
. Water with a full water jet.


Special hazards arising from the substance or mixture
..Can be released in case of fire
. Carbon monoxide (CO)

Advice for firefighters
Protective equipment:
. Do not inhale explosion gases or combustion gases.
. Wear self-contained breathing apparatus.

Additional information
. Cool endangered containers with water spray jet.
. Collect contaminated fire fighting water separately. It must not enter drains.
.

Accidental release measures

Personal precautions, protective equipment and emergency procedures
- Wear protective equipment. Keep unprotected persons away.

Environmental precautions:
- Do not allow to enter drainage system, surface or ground water.

Methods and material for containment and cleaning up:
- Ensure adequate ventilation.
- Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
- Send for recovery or disposal in suitable containers.

Reference to other sections
- See Section "Handling and storage" for information on safe handling
- See Section "Exposure controls/personal protection" for information on personal protection equipment.
- See Section "Disposal considerations" for information on disposal.
.

Handling and storage

Precautions for safe handling
- Ensure good ventilation/exhaustion at the workplace.

Information about protection against explosions and fires:
- Keep ignition sources away - Do not smoke.
- Protect against electrostatic charges.


Conditions for safe storage, including any incompatibilities
Storage
Requirements to be met by storerooms and containers:
- Store only in the original container.

Information about storage in one common storage facility:
- Store away from oxidising agents.

Further information about storage conditions:
- Protect from the effects of light.

Recommended storage temperature:
- > 0 °C


Specific end use(s)
- No further relevant information available.
.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

For one use this substance is handled under Strictly Controlled Conditions. Site documentation to support safe handling arrangements including the selection of engineering, administrative and personal protective equipment controls in accordance with risk -based management systems is available at each Manufacturing site.


Exposure controls
Personal protective equipment
General protective and hygienic measures
- The usual precautionary measures should be adhered to general rules for handling chemicals.
- Take off immediately all contaminated clothing
- Store protective clothing separately.
- Be sure to clean skin thoroughly after work and before breaks.
- Use skin protection cream for preventive skin protection.

Breathing equipment:
- In case of brief exposure or low pollution use breathing filter apparatus . In case of intensive or longer exposure use breathing apparatus that is independent of circulating air.
- Filter A (EN 14387)

Protection of hands:
- Only use chemical-protective gloves with CE-labelling of category III (EN 374).

Material of gloves
-Nitrile rubber
.. Recommended thickness of the material: ≥ 0,425 mm
.. Value for the permeation: 60 - 120 min
- Fluorocarbon rubber (Viton) / Butyl rubber
.. Recommended thickness of the material: ≥ 0,7 mm
.. Value for the permeation: > 480 min
-The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer.

Penetration time of glove material
- The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be observed.

As protection from splashes gloves made of the following materials are suitable:
- Butyl rubber, BR
- Nitril rubber, NBR

Eye protection:
- Tightly sealed safety glasses (EN 166)

Body protection:
- Protective work clothing (EN 340).
.


Stability and reactivity

Reactivity
- No further relevant information available.


Chemical stability
Thermal decomposition / conditions to be avoided:
- No decomposition if used according to specifications.


Possibility of hazardous reactions
- No dangerous reactions known


Conditions to avoid
- No further relevant information available.


Incompatible materials:
- No further relevant information available.


Hazardous decomposition products:
- No dangerous decomposition products known
.

Disposal considerations

Waste treatment methods
Recommendation
- Remove according to local authority recommendations, e.g. convey to a suitable incinerator.

European waste catalogue
- The disposal of waste within the EU is regulated by Directive 2008/98/EC
- The waste code classification is to be carried out according to the European Waste Catalogue (EWC) specifically for each branch of industry and each type of process.

Uncleaned packagings:
Recommendation:
- Disposal must be made according to official regulations.
.