Registration Dossier

Diss Factsheets

Guidance on Safe Use

Guidance on Safe Use

Currently viewing:

Administrative data

First-aid measures

General information

Remove contaminated, saturated clothing immediately. If unconscious place in recovery position and seek medical advice. First aider: Pay attention to self-protection! Remove affected person from the danger area and lay down.

Following inhalation

Remove casualty to fresh air and keep warm and at rest. If breathing is irregular or stopped, administer artificial respiration. In case of inhaling spray mist, consult a physician.

In case of skin contact

After contact with skin, wash immediately with plenty of water and soap. In case of skin reactions, consult a physician.

After eye contact

In case of contact with eyes flush immediately with plenty of flowing water for 10 to 15 minutes holding eyelids apart and consult an ophthalmologist.

After ingestion

If accidentally swallowed rinse the mouth with plenty of water (only if the person is conscious) and obtain immediate medical attention. Do NOT induce vomiting. Observe risk of aspiration if vomiting occurs.

Fire-fighting measures

Extinguishing media

Suitable extinguishing media

Carbon dioxide (CO2) , Foam , Water mist , Extinguishing powder

Special hazards arising from the substance or mixture

In case of fire may be liberated: Carbon dioxide (CO2) , Carbon monoxide.

Advice for firefighters

Wear a self-contained breathing apparatus and chemical protective clothing. Collect contaminated fire extinguishing water separately. Do not allow entering drains or surface water.

Accidental release measures

Personal precautions, protective equipment and emergency procedures

For non-emergency personnel

Remove all sources of ignition. Provide adequate ventilation. Use personal protection equipment.

For emergency responders

Use personal protection equipment.

Environmental precautions

Do not allow to enter into surface water or drains. Do not allow to enter into soil/subsoil.

Methods and material for containment and cleaning up

For containment

Cover drains. Prevent spread over a wide area (e.g. by containment or oil barriers).

For cleaning up

Take up mechanically, placing in appropriate containers for disposal. Use appropriate respiratory protection. Wear personal protection equipment

Handling and storage

Precautions for safe handling

All work processes must always be designed so that the following is excluded: Inhalation of dust/particles , Skin contact , Eye contact . Provide adequate ventilation as well as local exhaustion at critical locations. Keep away from sources of ignition. - No smoking. Only wear fitting, comfortable and clean protective clothing. Wash hands and face before breaks and after work and take a shower if necessary. Take precautionary measures against static discharges. When using do not eat, drink, smoke, sniff. Immediately remove any contaminated clothing, shoes or stockings. In the immediate working surroundings there must be : Emergency shower installed . Provide eye shower and label its location conspicuously .

Conditions for safe storage, including any incompatibilities

Keep container tightly closed in a cool, well-ventilated place. Take precautionary measures against static discharges. Store in a place accessible by authorized persons only. Only use the material in places where open light, fire and other flammable sources can be kept away.

Specific end use(s)

The substance/product is registered with strictly controlled conditions as defined in Article 18(4) of Regulation (EC) No. 1907/2006 (REACH Regulation)and must therefore be handled as such.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all
Shippingopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Exposure controls

Control any potential exposure using measures such as contained or enclosed systems, properly designed and maintained facilities and a good standard of general ventilation. Drain down systems and transfer lines prior to breaking containment. Drain down and flush equipment where possible prior to maintenance. Where there is potential for exposure: Ensure relevant staff are informed of the nature of exposure and aware of basic actions to minimise exposures; ensure suitable personal protective equipment is available; clear up spills and dispose of waste in accordance with regulatory requirements; monitor effectiveness of control measures; consider the need for health surveillance; identify and implement corrective actions.

Appropriate engineering controls

Technical measures and the application of suitable work processes have priority over personal protection equipment. Reduce exposure to fume by keeping operating temperatures as low as possible taking into account occupational exposure limits and safe handling temperatures. Where practicable handle within an enclosed process. Alternatively local exhaust ventilation should be considered.

Eye/face protection

goggles

Skin protection

When handling with chemical substances, protective clothing with CE-labels including the four control digits must be worn. Required properties : flame-retardant , antistatic. Draw up and observe skin protection programme.

Hand protection

Tested protective gloves must be worn . The quality of the protective gloves resistant to chemicals must be chosen as a function of the specific working place concentration and quantity of hazardous substances. For special purposes, it is recommended to check the resistance to chemicals of the protective gloves mentioned above together with the supplier of these gloves.

Respiratory protection

If technical exhaust or ventilation measures are not possible or insufficient, respiratory protection must be worn. Suitable respiratory protection apparatus : dust mask

Stability and reactivity

Chemical stability

The substance is chemically stable under recommended conditions of storage, use and temperature.

Incompatible materials

Violent reaction with: Alkali (lye), concentrated. Oxidising agent, strong.

Disposal considerations

Waste treatment methods

The allocation of waste identity numbers/waste descriptions must be carried out according to the EEC, specific to the industry and process. Dispose of waste according to applicable legislation.

Product/Packaging disposal

Appropriate disposal / Package

Non-contaminated packages may be recycled. Contaminated packages must be completely emptied and can be re-used following proper cleaning. Handle contaminated packages in the same way as the substance itself.